SLOPE PANEL
STARTING PROFILE
CASH
LATCH
ANGULAR COVER
Installation of a standard window (1500/1500 / 200mm) with a skid system
QÜNELL specialist takes about an hour
RECOMMENDED INSTALLATION TOOL KIT
- Screwdriver
- Bits long and short
- Screwdriver set with magnetic tips
- A set of drills for metal or a pair of drills with a diameter of 3mm
- Level 50 + 100 cm
- Hacksaw
- Narrow bar
- Square, pencil, tape measure
- Painter’s knife 18 or 25 mm
- Angle cutting machine with a disc of 115 or 125 mm (disc thickness should be min 1.2 mm)
- Self-tapping screw LN 9 mm piercing with a standard head (for a starting profile) + anchors with self-tapping screws for fastening latches (for example, a plastic anchor with a self-tapping screw 4х40) depending on the wall material
- Cosmophen-20 or plastic cleaner
CARE AND STORAGE
Contamination on products that appear during operation must be removed using neutral detergents.Do not use abrasive cleaners (usually powders, pastes, less often -- suspensions).
Products should be stored in covered warehouses at a temperature not lower than 0 ⁰C and at a distance of at least 1 m from heating appliances.
